top of page

Ce que nous représentons chez Comfort geothermal!

Une formation adéquate, l'expérience et l'honnêteté d'un technicien certifié sont essentielles au service dans n'importe quel métier.

 

Du sujet le plus simple au métier plus technique et spécialisé comme
thermo pompe géothermiques. Une installation adéquate par un installateur qualifié est la clé d'un système de chauffage efficace et durable pour votre maison ou votre bâtiment avec un système géothermique ou tout autre système de chauffage.


Les propriétaires doivent toujours demander et ont le droit de demander une preuve de certification de qualification à un technicien/installateur. Après tout, c'est votre maison et vous méritez le meilleur.

Nos services

Desservant les régions Chaleur, Restigouche et Péninsule acadienne avec un service entièrement bilingue.
Test de fuite

Essais et réparations de fuites de systèmes de réfrigération et de thermo pompe

Diagnostic électrique et mécanique

Diagnostiques et réparations électriques et mécaniques

Remplacement du compresseur

Test d'efficacité
Réparation/remplacement

Test de boucle de terre et pressurisation

Rinçage, mise sous pression, test de gravité spécifique et réparations du centre d'écoulement

Diagnostique du système

Systèmes de réfrigération complets 

 Systèmes de thermo pompe géothermiques
 

Entretien 

Service de maintenance préventive pour garder votre
système fonctionnant au maximum de son efficacité

Questions fréquemment posées

  • How does a Geothermal heat pump compare to an air source model?
    A- With an air source heat pump, the outside air is often subject to very cold sub zero temps, as well as other often very damaging elements such as snow, ice storms, falling ice, combined with wind can cause costly repairs to these units. Also a defrost system is required to these units, which requires additional controls, sensors, timers, snow clearing around an bellow the unit for the defrost water to run off clear of the outdoor coil. Not to mention the fan blades that are very sensitive to ice and snow build ups, causing further costly damage. These high cost repairs are not covered by warranties. B- A geothermal heat pump has no outdoor component in the elements, but rather in ground piping, bellow the frost line, whether it be vertical or horizontal. No matter the outdoor weather, your heat source is at a constant above freezing temperature, requires no defrost controls of any kind, but simply a low energy cost pumping module inside the home to recirculate the liquid (closed loop systems) as it absorbs the natural heat from the earths core (vertical loops) and the heat left by the sun (down to 10 ft) into the earth from the previous summer. As an added benefit, the heat removed from your home in the summer while you enjoy the air conditioning feature is stored around the loop area, only to be reabsorbed to heat your home in the winter, making this system an incredibly efficient renewable energy source.
  • How do I decide which type of geothermal system I should install?
    It depends on land size and type. If you are on a large lot, a horizontal closed loop is suitable and less costly to install. But if your lot is all rock, or a dry sand type, a vertical drilled borehole will be best. Wet, clay type ground is best as it holds lots of humidity and energy.
  • What is the difference between open loop and closed loop systems?
    An open loop system takes water from a water source, usually a well, circulates it threw the heat pump to absorb heat from the water, then returns it to a separate well back into the ground. The returned water is simply colder and completely uncontaminated. The wells must be far enough apart so that the colder water cannot short cycle into the supply well. A closed loop system recirculates the same water threw a horizontal or vertical piping system. This system does not rely on a well water pump, but rather a 1 or 2 pump flow module.
bottom of page